IPS12060G
Switching power supply/Battery charger
providing 3.2A @ 13.8V
The IPS12060G switching power supply/battery charger has been designed and
manufactured to the highest standards of quality, reliability and performance adopted
by INIM Electronics. INIM Electronics guarantees that the components selected for this
product will operate properly within their specifications when the environmental
conditions outside the enclosure comply with Class 3k5 (EN 60721-3-3).
The IPS12060G unit provides a regulated 13.8V and 2A maximum current by means of
the “
+V
” and “
-V
” terminals.
The outputs are overload, short-circuit and reverse polarity protected.
The unit can be equipped with an optional thermal probe (ProbeTH see the Inim
catalogue) which is capable of maintaining the battery charge current at the appropriate
level for efficient battery charging.
A
Mains input terminal board
B
Battery connector
BAT-
,
BAT+
C
Output terminal board
+V
,
-V
D
Output connector
RTH
,
FAULT
,
-V
,
+V
E
Thermal probe connector
NTC
F
OC output connector
STATUS
G
Serial port connector
(reserved)
SERIAL
H
LED indicators
I
Ground fault signalling jumper input
J
Anchor screw hole (Ø 3.25mm)
N
L
230V ~ 50/60 Hz
AC Input
A
J
G
H
J
F
E
B
C
D
I
F
GND OC2 OC1 +V
STATUS
Technical characteristics
Mains supply voltage
230V~ (-15%/+10%)
50/60Hz
Absorbed current
0.5A (max)
Output voltage
13.8V
(±1%)
Operating output voltage
from 9 to 13.8V
Battery shutdown tension
9.5V
Maximum output ripple
1%
Maximum out-
put current
total
3.2A
for external load
2A
for battery
recharge
1.2A
Connectable battery
(or equivalent with case flame
class UL94-V2 or higher)
12V – 7Ah or 17Ah
YUASA NP-12 FR
Unreplaceble protection fuse (F1)
T 3.15A 250V
Maximum internal resistance of
battery
2.7 Ohm
Operating temperature
from -5 to +40 °C
Isolation class
I
Dimensions (W x H x D)
138 x 42 x 87 mm
Weight
0.450 Kg
En
glish
EN IEC 62368-1
