23
MAINTENANCE SECTION
5.
Install the Housing Screws (80 or 83) into the Housing
and tighten to 4 KG–cm.
6.
Slide the Flange (2) onto the Housing. Screw the
Retainer Coupling (1) onto the Housing until it clicks
into place.
These are left–hand threads.
7.
Attach the Power Cord (81 or 84).
Testing the Tool
1.
Test forward and reverse operation by pressing the Bit
Holder against the work surface with the Reverse
Switch in each position.
2.
Tighten the Clutch Adjusting Ring all the way, reverse
it one turn and test for proper shut off operation and
maximum torque.
3.
Reset the Clutch Adjusting Ring to mid scale and
check for torque repeatability by cycling the tool
between five and ten times.
4.
For repair and troubleshooting of the high torque low
voltage Controller, refer to the operation and
maintenance manual.
WIRING DIAGRAM FOR EP1510E 230V
(Dwg. TPA1531)
