Book 35393065 (7/02)
39
( )
COMPRESSOR OIL
The lubricating and cooling oil must be replaced every
500 hours of operation or six (6) months, whichever
comes first.
RECEIVER--SEPARATOR SYSTEMS
WARNING
High pressure air can cause severe injury or death
from hot oil and flying parts. Always relieve
pressure before removing caps, plugs, covers or
other parts from pressurized air system.
S
Open service valve at end of machine.
S
Ensure pressure is relieved, with BOTH:
-- Discharge air pressure gauge reads zero (0).
-- No air discharging from service valve.
When draining oil, remove plug from the separator
tank drain fitting.
When adding oil, remove and replace (make tight)
plug on side of separator tank.
In the compressor lubricating and cooling system,
separation of the oil from the compressed air takes
place in the receiver--separator tank.
As the
compressed air enters the tank, the change in velocity
and direction drop out most of the oil from the air.
Additional separation takes place in the oil separator
element which is located in the top of the tank.
Any oil accumulation in this separator element is
continuously drained off by means of a scavenge tube
which returns the accumulated oil to the system.
Содержание P130WJDU
Страница 28: ...Book 35393065 7 02 28 Figure Z...
