Ingersoll-Rand ENL 5, Инструкция по установке и эксплуатации

Страница: 6 / 96

6 ingersollrandproducts.com 80442874
EN
6. ELECTRICAL DATA
Supply voltage
(see type plate)
95…240 VAC ±10% (50…60 Hz) /100…125 VDC ±10%
or
24…48 VAC ±10% (50…60 Hz) / 18…72 VDC ±10%
Power consumption P = 0,6 ... VA (W)
Recommended
cable-jacket diameter
Ø 5,0…10 mm (0,20“…0,9“)
Recommended
wire cross-section
Spring-loaded terminal (voltage supply/relay)
0,75...1,5 mm² (AWG 16...20)
Recommended
wire cross-section
Screw terminal (voltage supply)
0,75...2,5 mm² (AWG 14...20)
Recommended
wire cross section
Spring-loaded terminal (external test)
0,75...1,0 mm² (AWG 18...20)
Recommended
wire cross section
Screw terminal (relay/external test)
0,75...1,5 mm² (AWG 16...20)
Recommended
stripping of cable jacket (voltage supply/relay)
~ 0 mm (~ 1.18”)
Recommended
stripping of cable jacket (external test)
~ 90 mm (~ .54”)
Recommended
length of the wire end tube
Spring-loaded terminal
8 mm (~ 0.1 inch)
Recommended
length of the wire end tube
Screw terminal
~ 6 mm (~ 0.24 inch)
Connection data of the potential free
contact Switch to load*)
AC: max. 250V / 1A
DC: max. 0V / 1A
Connection data of the
potential-free contact
Switch to low signal*)
min. 5 VDC / 10 mA
Connection data of the
external test contact
on the unit side 5 VDC; switching current ≥ 0,5 mA
Protection class IP 67
Overvoltage category
(IEC 61010-1)
II
VAC = V alternating current
VDC = V direct current
*)
The switching of loads means that the properties of the contact are no longer suitable
for the switching of low signals.