Ingersoll-Rand Club Car VILLAGER 8 ELECTRIC, Руководство оператора

Страница: 70 / 88

Page 68
VILLAGER 8 ELECTRIC
Operators Manual
TPCC01CI00EN021 (Edition C)
3. Disconnect the positive (+) cable (2).
4. Wait 90 seconds for the controller capacitors to discharge.
CONNECT THE BATTERIES
DANGER
BATTERIES DISCONNECTED OR CONNECTED WITH THE RUN/
TOW SWITCH SET TO RUN CAN CAUSE A BATTERY EXPLOSION
AND SERIOUS PERSONAL INJURY. SET THE RUN/TOW SWITCH
TO TOW BEFORE THE BATTERIES ARE DISCONNECTED OR
CONNECTED.
1. Set the Run/Tow switch to TOW.
2. Connect the positive (+) cable (2).
130798-000017
(-)
(
+
)
1
2
G-
3. Connect the negative (-) cable (1).
WARNING
LOOSE BATTERY WIRES CAN CAUSE A FIRE, PROPERTY DAMAGE,
OR SERIOUS PERSONAL INJURY. MAKE SURE THAT ALL BATTERY
WIRES AND TERMINALS ARE CLEAN AND TIGHTENED
CORRECTLY.
4. Tighten the hardware to 110 lb·in (12.4 N·m).
5. Apply battery terminal protector spray to the battery terminals.
6. Set the Run/Tow switch to RUN.
BATTERY HOLD-DOWN
Each hold-down must be tight to prevent the battery movement while the vehicle is in operation. Do
not tighten too much or the battery case can crack or buckle.
1. Tighten the hold-down nuts to 110 lb·in (12.4 N·m).
ADD WATER TO A BATTERY WITHOUT SINGLE POINT WATERING
SYSTEM
This information is for batteries without a Single Point Watering System (SPWS).
Before water is added:
9
Battery Maintenance
Battery Hold-Down