Wheel and Tire Installation
2007 Carryall 272/Turf 272 Gasoline Vehicle Owner’s Manual (Europe)
Page 35
WHEEL AND TIRE INSTALLATION
NOTE:
Upon vehicle delivery, the shipping wheel and tire assemblies must be replaced by the standard
wheel and tire assemblies, which are delivered in the vehicle cargo bed.
Do not remove the warning tag attached to the steering wheel until the shipping wheel and tire
assemblies have been replaced by the standard wheel and tire assemblies.
1. Slightly loosen the lug nuts on all four wheels.
2. Raise one end of the vehicle until the tires are off the ground by approximately 15.2 cm (six inches).
See
following WARNING.
ý
WARNING
• Lift only one end of a vehicle at a time. Before lifting, set the park brake when lifting the front
of the vehicle, unload the cargo bed, and chock the wheels that remain on the floor. Use a
suitable lifting device (chain hoist or hydraulic floor jack) with 454 kg (1000 lb.) minimum
lifting capacity. Do not use lifting device to hold vehicle in raised position. Use approved jack
stands of proper weight capacity to support vehicle.
3. Remove the lug nuts and the wheel.
4. Install the wheel and tire assembly and tighten lug nuts (using a crisscross pattern) until they are snug.
5. Repeat steps 3 and 4 for the other side of the vehicle.
6. Lower the vehicle to the ground and finish tightening lug nuts (using a crisscross pattern) to 74.6 N·m (55
ft-lb.).
7. Repeat steps 2-6 for the other end of the vehicle.