SP0665S2XXXXXXXX (en)
Page 3 of 4
TO RAISE LIFT, (NORMAL OPERATION):
1. Close the pump air supply valve.
2. Adjust the follower plate air valve pressure up to approx-
imately 8 psig (0.55 bar). DO NOT OVER PRESSURIZE THE
DRUM to avoid damage. NOTE: Air from this valve will
only pass when the control lever is in the “up” position.
3. Shift the control valve lever to the “up” position.
4. Raise the lift / ram high enough to clear the height of the
drum. Stop the lift upward travel by moving the control
valve lever to the “neutral” (center) position.
TO CHANGE THE DRUM:
NOTE:
The control valve lever must be in the “neutral” posi-
tion and the pump air supply valve should be closed.
1. To avoid damage, DO NOT OVER PRESSURIZE THE DRUM.
2. Open the follower plate air supply valve to allow air un-
der the follower plate.
3. Shift the control valve lever to the “up” position.
4. Unscrew the thumb screw and remove the old drum.
PARTS LIST / SP0665S2XXXXXXXX
Item Description (size)
Qty Part No.
1 Pump Assembly
(1) AF0665S1XXXXX
*2 Male Elbow
(1/2 - 14 NPT x 1/2” o.d. tube)
(included with item 3)
(1) 59756-362
*3 Single Post Lift / Ram
(1) RM051S-XXX-XX-B
*4 Follower Assembly
(see "Model Description Chart", page 1)
(1)
5 Washer
(3/8”)
(4) Y13-6-C
6 Cap Screw
(3/8" - 16 x 1-1/2”)
(4) Y6-67-C
7 Lock Washer
(3/8”)
(4) Y14-616-C
Item Description (size)
Qty Part No.
8 Nut
(3/8” - 16)
(4) Y12-6-C
9 Wet-Sol “Plus”
(1 quart) (not shown)
(1) 66333-B
*10 Tubing
(5/16” od x 38”)
(1) 94980-(
)
*11 Tubing
(1/2” od x 33”)
(1) 94978-(
)
*12 Cap Screw
(4) Y99-63-C
*13 Male Elbow
(1) 59756-58
Bulk Tubing
(1/2” od x 100’)
(1) 94978-100
Bulk Tubing
(5/16” od x 100’)
(1) 94980-100
*
Included with RM051S-XXX-XX-B.
1
2
3
4
6
10
12
13
5
7
8
11
Figure 3
DIMENSIONAL DATA
ASSEMBLY TORQUE REQUIREMENTS
NOTE: DO NOT OVERTIGHTEN FASTENERS.
(6) cap screw, 25 - 30 ft lbs (33.9 - 40.7 Nm).
LUBRICATION / SEALANTS
Apply anaerobic pipe sealant to all male pipe threads.
