47109509_ed2
7
12. Apply a thin film of grease to the Liner O–ring (34) and install it in
the forward bore of the Housing.
13. Lubricate the Front and Rear Liner Seals and after orienting the
Housing to the proper position, install the Housing over the Liner.
14. Grasp the flats of the Housing in vise jaws with the output spindle
downward. Remove the Rear Liner Cover Assembly and put
grease in the central opening of the Cover.
Refer to Dwg. TPD1313.
Grease
(Dwg. TPD1313)
15. Reinstall the Cover Assembly and use a hex wrench to push it
below the threads at the rear of the Housing.
Refer to Dwg. TPD1314.
(Dwg. TPD1314)
16. Install the Housing Cap (35) and using the spanner plug furnished
in the Tool Kit, tighten the Cap between 58 and 65 ft–lb (78 and
88 Nm) torque.
Refer to Dwg. TPD1315.
Spanner Plug
Clockwise to Tighten
(Dwg. TPD1315)
17. Make certain the Drive Shaft rotates freely and then fill the
mechanism with fluid and reassemble the tool as instructed in
the section, CHANGING THE MECHANISM FLUID.
Related Documentation
For additional information refer to:
Product Safety Information Manual 04584983.
Product Information Manual 47133053.
Parts Information Manual 47135488.
Manuals can be downloaded from ingersollrandproducts.com
