Ingersoll-Rand 10/125, Руководство по эксплуатации и техническому обслуживанию

Страница: 100 / 133

Operating & Maintenance Manual Maintenance
100 22442594
Reassembly
Clean the filter gasket contact area and install the new element by screwing in a clockwise
direction until the gasket makes contact with the filter housing. Tighten a further ½ to ¾ of a
revolution.
CAUTION
!
Start the machine (refer to PRIOR TO STARTING and STARTING THE
UNIT in the OPERATING INSTRUCTIONS section of this manual) and
check for leakage before the machine is put back into service.
Compressor Oil Separator Element
Normally the separator element will not require periodic maintenance provided that the air and
oil filter elements are correctly maintained.
If, however, the element has to be replaced, then proceed as follows:
Removal
WARNING
!
Do not remove the filter(s) without first making sure that the machine is
stopped and the system has been completely relieved of all air pressure.
(Refer to STOPPING THE UNIT in the OPERATING INSTRUCTIONS
section of this manual).
Disconnect all hoses and tubes from the separator tank cover plate. Remove the drop-tube
from the separator tank cover plate and then remove the cover plate. Remove the separator
element.
Inspection
Examine the filter element. Examine all hoses and tubes, and replace if necessary.
Reassembly
Thoroughly clean the orifice/drop tube and filter gasket contact area before reassembly. Install
the new element.