77700-084
Rev.
G
07/02
Page
4
of
13
75.0073 Nov 01 [Rev 8/8/2002]
WIRING DIAGRAM
Be absolutely certain that no power is applied to any wires until all wiring and connections are complete and the sensor is
ready to be powered up and tuned. With the terminal block properly installed at the left side of the sensor, terminal #1 will
be farthest from the mounting surface and the screws for the terminals will be facing down. The terminal block may be
pulled out to allow ease of wiring. Once all wiring is complete, the lenses and center eye shield may be installed. Note:
leave the end caps off until programming is complete in case the adjustment angle has to be altered.
WIRING DIAGRAM FOR ASTRO-SWING CONTROL
