5.4
Log Data Output
5.5 Deleting Log Data
The data logger has to run in
stand-by
mode in order to be able
to initiate the data output. If the data logger runs in
logging
mode,
you have to stop logging by pressing the red STOP button or
switching the data logger off and on again with the blue ON/OFF
button (see 5.3). Press the grey SHIFT and the green START
button simultaneously until the reversed triangle LED lights up
and the control LED lights green:
Log data output will continue as long as the LEDs are active, so
ensure that the connection to the PC is not disrupted. When the
log data output has been completed the data logger returns to
stand-by
mode.
Press the grey SHIFT and the red STOP button simultaneously
until the triangle LEDs begin to flash alternately and the control
LED flashes red:
When the flashing has stopped the data memory of the data
logger memory is ready to store new log data.
Stored log data cannot be deleted until log data output has been
performed at least once. This will be indicated by flashing of the
upright triangle LED for 10 times and red flashing of the control
LED for 5 times:
If you have collected some log data which are of no use for you
and thus should be deleted without preceding log data output, it
is necessary to press the grey SHIFT plus the red START button
and wait until the log data output has been completely finished
to be able to delete these log data. If the log data output has
not been carried out using the MOUSE-E-MOTION software, it
is necessary to press the SHIFT plus STOP buttons for at least
8
seconds. (This has been implemented to minimize the risk of
unintended deletion of log data which have not been downloaded
with the MOUSE-E-MOTION software.)
- 9 -
Co
n t
rol
C
on t r
ol
10x
C
on t r
ol
5x
