LL1000V® Tag Printer Copyright © 2003-20016 InfoSight Corporation All Rights Reserved
Page 1
PRINTER SETUP
The LABELASE
1000 Vector Tag Printer requires 100-240 VAC, 50/60 Hz, 2.4 A.
NOTE:
both sides of the incoming line voltage are fused. See the Maintenance section for
instructions on replacing fuses.
The LABELASE
®
1000 Vector Tag Printer should be positioned so that the power supply cord exits from
the back of the machine.
The LABELASE
1000 Vector Tag Printer should be placed in a temperature controlled environment.
This marker, though designed for industrial use, should be treated as any typical computer system and
printer. Dirty environments will necessitate a more frequent cleaning schedule for internal optics.
NOTE:
If the printer is housed in a secondary protective enclosure, the two exhaust fans located on the
bottom of the printer directly underneath the tag feed drive area must not be obstructed. Ideally the fans
should be exhausted to the environment outside the enclosure, with clean & dry makeup air entering the
enclosure toward the back of the printer near the foam element air filter.
An RS-232 serial communications cable is provided for communicating with your Windows-based PC. A
USB cable is also provided with the USB/Ethernet communications module. See the serial connector
wiring diagram at the back of this manual for additional information if another serial cable is required.
The LabeLase 1000 Vector Tag Printer should be positioned near the chosen fume extractor. The hoses
should be properly attached. An outlet exists on the back of the machine intended to power the fume
extractor. The outlet for the fume extractor is rated at 3 amps. Plug the fume extractor power cord into this
outlet.
Caution:
The Vector Exhaust Printer Model has a US
– style power jack on the back panel. The
LabeLase
®
Producer
TM
Software controls the switching of this AC output jack. This jack provides
output power of the same voltage/frequency as the input power but is limited to 3 amps output
current.
The user MUST select a model of exhaust system that matches the voltage of the input voltage to
the LL1000V printer. The current draw of the exhaust system must be less than 3 amps.
SOFTWARE INSTALLATION
Before connecting the printer to your PC, LabeLase® Producer™ software should first be installed on your
PC.
The easiest way to install the software is to use the Installer Thumb Drive that came with your new printer.
In addition to installing the correct version of Producer™ and Designer for your specific printer model, it
will also allow you to configure the appropriate communications interface.
If your original Installer Thumb Drive is not available OR for the latest release of Producer™ and Designer
software, downloaded the installer package directly from
http://www.infosight.com/support/software/37-
labelase-producer-metal-tag-production-software
. This is a self-contained, single self-installing file.
However, it will not automatically guide you through the configuration process for communications, and
you must therefore follow the steps outlined in the LabeLase® Producer™ Software Installation Manual.
