InfoPrint 6500-v05, Руководство пользователя

Страница: 225 / 340

Chapter 6. Reprogramming The Security Key
The security key on the PSA3 controller board can be reprogrammed with a
Software Program Exchange (SPX) module.
The SPX is an intelligent module that plugs into the debug port on the back of
printers equipped with the PSA3 “Hurricane” controller board. The SPX is used
only once; it automatically overwrites itself after successfully reprogramming a
security key. This allows the end user or a service technician to enable features
such as new emulations without having to remove covers and install a new
security key on the controller board.
The SPX is used at power-up only and is not left in the printer during normal
operation. Because it is a single-use disposable item the user is not required to
return it to the vendor or manufacturer.
How To Reprogram The Security Key
1. Power off the printer.
2. On cabinet models, open the rear door. On pedestal models, refer to Figure 66
to locate the debug port at the rear of the printer.
3.
Insert the SPX into the debug port as shown.
4. Power on the printer. The printer will begin its boot-up sequence.
5. When the printer detects a valid SPX, the control panel displays:
"NEW SPX DETECTED
PRESS ENTER"
Note: If an error message displays, find the message in the “Fault Messages”
on page 221 and follow the troubleshooting instructions.
Figure 66. Inserting the SPX into the Debug Port
© Copyright InfoPrint Solutions Company 2005, 2010
209