InfoPrint 6500 DBCS, Руководство пользователя

Страница: 137 / 230

Fault Correction Procedure
137
Fault Messages
If a fault condition occurs in the printer, the Attention indicator on the operator
panel lights, and the first line of the operator panel message display indicates
the fault. The second line of the display indicates how to clear the fault.
Table 8: explains each fault message and describes how to correct the fault
condition. Displayed faults fall into one of two categories:
•
Operator correctable.
•
InfoPrint service representative required to correct.
Fault Correction Procedure
Before correcting a fault, read the fault explanation, then proceed to fix the
problem, taking the following steps:
1. Write down the number of the error message(s) being displayed.
2. Read the fault explanation, then proceed to fix the problem, if possible.
3. Press STOP to clear the fault message. Press START to return to Ready
mode, and resume printing.
4. If the fault message reappears, power off the printer, wait 15 seconds,
then power on the printer.
5. Run your print job again. If the fault message reappears, turn off power to
the printer, then call your InfoPrint service representative. Otherwise, no
further attention is required.
The following table explains each fault message and offers suggestions for
correcting the fault condition.
Table 8: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution
001 END OF FORMS
LOAD FORMS
Yes Printer is out of paper. Load paper. Refer to the
InfoPrint 6500 Line Matrix
Printers: Quick Start
Guide
.
002 FORMS JAMMED
CLEAR AND RELOAD
FORMS
Yes No paper motion. Clear paper jam and
reload paper. See the
User’s Manual. Reset
platen lever.
003 FORMS EJECTED
PRESS EJECT/RESTORE
Yes Non–error status
message. Press the EJECT/
RESTORE key to return
paper to print position.