28
Settings menu
Audio
: allows adjustments to the volume and mute, and turns the projec-
tor’s startup Chime on and off.
Sources
:
allows you to assign a particular input to a specific source key on
the remote. Also allows selection of a default Startup Source and enables or
disables Autosource and RGB Video.
Sources>Startup Source:
this determines which source the projector
checks first for active video during power-up.
Sources>Autosource:
When Autosource is not checked, the projector
defaults to the source selected in Startup Source. If no source is found, a
blank screen displays. When Autosource is checked, Startup Source deter-
mines which source the projector defaults to at power-up. If no signal is
present, the projector checks the sources in order until a source is found or
until power down.
Sources>RGB Video:
check this box if you are using a DVD player with
RGB output.
System>Rear:
reverses the image so you can project from behind a translu-
cent screen.
Ceiling
: turns the image upside down for ceiling-mounted projection.
Auto Ceiling
: automatically senses when the projector is inverted and turns
the image upside down. This is On by default.
Auto Power
: When Auto Power is checked, the projector automatically
goes into the startup state after the projector is powered on. This allows con-
trol of ceiling mounted projectors with a wall power switch.
Display Messages
: displays status messages (such as “Searching” or
“Mute”) in the lower-left corner of the screen.
Power Save
: automatically turns the lamp off after no signals are detected
for 5 minutes. After 3 additional minutes with no signal, the projector pow-
ers down. If an active signal is received before the projector powers down,
the image will be displayed.
Screen Trigger
: turns on the 12 volt DC output switch on the connector
panel.
Backlight
: allows you to turn off the backlighting on the keypad.
Audio
Sources
Startup
Source
System menu
Screen Save
