28
Using the remote control
The remote uses two (2) provided AA batteries. They are easily installed by
sliding the cover off the remote’s back, aligning the + and - ends of the bat-
teries, sliding them into place, and then replacing the cover.
To operate, point the remote at the projection screen or at the projector (not
at the video device or computer). The range of optimum operation is up to
30 feet (9.14m).
Press the remote’s
Menu
button to open the projector’s menu system. Use
the arrow buttons to navigate, and the
Select
button to select features and
adjust values in the menus. See page 32 for more info on the menus.
The remote also has:
•
Power
button to turn the projector on and off (see page 20 for shut-
down info)
•
backlight button to light the remote’s buttons in the dark
•
Brightness
and
Contrast
buttons to adjust the image
•
Blank
button to display a blank screen instead of the current image (to
change the color of the screen, see page 39)
•
Source
buttons to switch among sources (to assign a particular source
to a source button, see page 38) and a source toggle
•
Resize
button to change the Aspect Ratio (see page 33)
•
Auto Image
button to resynch the projector to the source
•
Preset
button to restore stored settings (see page 34)
•
Overscan
button to remove noise in a video image (page 37)
Troubleshooting the remote
•
Make sure the batteries are installed in the proper orientation and are
not dead.
•
Make sure you’re pointing the remote at the projector or the screen, not
at the video device or the computer, and are within the remote range of
30 feet (9.14m).
backlight button
navigation buttons
