iii
SAFETY SUMMARY
Please read these instructions carefully before using your
LitePro 720 or 730. Failure to comply with them could result in
fire, electrical shock, personal injury or damage to equipment.
These graphics are used throughout this manual to draw your
attention to important information about the projectors.
NOTE: Additional useful details or tips.
CAUTION: Steps to take to avoid damage to your equipment.
WARNING: Steps to take to avoid personal injury.
These graphics are used on LitePro labels.
Attention
- Refer to this User’s Guide for important
safety information.
Hot Surfaces
- Avoid touching hot surfaces. Do not
touch until the LitePro has cooled.
Do Not Look Into The Lens!
Be extremely careful not to look into the projection lens when the
LitePro is turned on. The bright light may harm your eyes. Be
especially careful to keep children from looking into the lens.
Power Source
Use only a three-wire grounding type power source. The power
source should not exceed 250 volts rms between the supply con-
ductors or between either conductor and the ground.
Power Cord
Use only the power cord that was shipped with the LitePro.
Although other power cords might be similar in appearance, they
have not been safety-tested with the projector. Do not use a
power cord if it has become damaged or frayed. Contact your In
Focus dealer or call In Focus if you need to replace your power
cord.
Downloaded From projector-manual.com Boxlight Manuals