InFocus INF-MOTWALL/XSD1U, Руководство по установке

Страница: 8 / 24

INF-MOTWALL / XSD1U Installation Instructions
8
Assembly And Installation
The INF-MOTWALL / XSD1U can be to be mounted to:
• a bare concrete wall with a minimum thickness of
8" (203mm):
• a bare 8" x 8" x 16" (203mm x 203mm x 406mm)
concrete block wall;
• wood studs spaced 16" or 24" on center with a
maximum drywall covering of 5/8”; or
• a 2" x 4"-25ga minimum steel stud wall.
• a 1/2" minimum thickness plywood-backed, steel
stud wall covered with drywall having a maximum
thickness of 5/8".
Installing to Wood Stud Wall
1. Use a stud-finder to locate 16" or 24" studs.
2. Place top bracket (B) against wall at desired mounting
location 10 1/8" above the desired center of the screen. Use
a level to ensure a level mount. (See Figure 1)
3. Mark hole locations at each mounting location in the center
of each stud. (See Figure 1)
4. Drill two 7/32” holes at marked hole locations. (See Figure 1)
5. Install two 5/16 x 2 1/2” hex head cap screws (G) through
two 5/16" washers (H), holes on top bracket and into drilled
holes on wall. (See Figure 1)
Figure 1
CAUTION:
Use proper lifting techniques and two people to
install INF-MOTWALL / XSD1U assembly onto wall!
6. Carefully hang INF-MOTWALL / XSD1U assembly (A) onto
top bracket (B), making sure mount slides behind upper
flange on top bracket (B). (See Figure 2)
Figure 2
7. Remove screw holding bottom cover to INF-MOTWALL /
XSD1U assembly (A) and remove bottom cover. (See
Figure 3)
Figure 3
8. Mark hole locations for lower two mounting holes. (See
Figure 4)
9. Remove mount (A) from top bracket.
10. Drill two 7/32” holes at marked hole locations. (See Figure 4)
Figure 4
3 4
(G) x 2
5
7/32” (5.3mm)
(B)
(H) x 2
(B)
(A)
6
6
7
7
7
x x
8
10
7/32” (5.3mm)