Infoblox Infoblox-250-A, Руководство по установке

Страница: 4 / 16

Introduction
4 Infoblox Installation Guide
Hardware Components
The Infoblox-250-A appliance is a 1-U platform that you can easily mount in a standard equipment rack using the
mounting brackets and bolts that ship with each appliance. The front panel components include communication
ports and indicator lights. The rear panel components include the power connector and switch, fan, air vent, and
the model and serial number label.
Front Panel
The front panel components are shown in Figure 2 and described in Table 1 . For explanations of the Ethernet port
LEDs, and console and Ethernet port connector pin assignments, see Ethernet Port LEDs on page 5 and Connector
Pin Assignments on page 6.
Figure 2
Infoblox-250-A, Front Panel
Table 1 Front Panel Components
Component Description
USB Port Reserved for future use.
Console Port A male DB-9 serial port for a console connection to change basic configuration settings
and view basic system functions through the CLI (command line interface). Use the
serial cable and connection adapters that ship with the appliance to make a console
connection to this port.
Only a properly grounded USB-to-Serial dongle is allowed to connect to the serial
console port. If the dongle is connected to a laptop, this laptop must be grounded
properly as well. Failure to do so may result in damage to the serial console port of the
Infoblox appliance. Infoblox is not responsible for such damage.
HA Port
Console Port
LAN2 Port
USB Port
MGMT Port
LAN1 Port
Drive Indicator
Power Indicator