infobit iSwitch 265, Руководство пользователя, Страница: 8 / 27

6/22
9 IR IN
12V IR signal input port.
10 RS-232
RS-232 serial port, supporting signal pass-through and local
serial port control.
11 IN-AUDIO-OUT
AUDIO IN: Analog stereo audio input port. Connect to an
audio input source device.
AUDIO OUT: Analog stereo audio output port. Connect to an
audio output device.
12 HDMI OUT
HDMI local loop output port, connect to an HDMI display
device such as TV or monitor.
13 HDMI IN
HDMI input port, connect to an HDMI source device such as
DVD or Set-top box with an HDMI cable.
14 LAN (POE)
100M/1G Network port. Connect to a Switch/Router/Hub for
data transmission or POE function.
15
Link Signal
Indicator lamp
(Green)
▪ Illuminating: The network cable is connected normally.
▪ Dark: The network cable is not connected well.
16
Data Signal
Indicator lamp
(Yellow)
▪ Flashing: There is data transmission.
▪ Dark: There is no data transmission.
17 DC 12V
The device can be powered via two methods:
▪ Local DC 12V/1A power supply
▪ POE from Network Switch. Device acts as PD mode.
When the Switch supports POE function, DC power supply
is not needed.
Notes:
Encoder can choose HDMI audio input or external audio embedding. It can be set
through the CH SELECT buttons on the front panel of the Encoder. (The default setting
is HDMI audio input.)
If it is set to HDMI audio input, the L/R OUT output of Encoder is HDMI audio loop out.
If it is set to external audio embedding, the L/R IN input of Encoder is the input of
external audio embedding, and the L/R OUT output is the external audio embedding
loop out.
Description of the LED screen and CH SELECT buttons (For the Encoder).
1, After the system is powered on, the Encoder’s LED screen will show the ENC ID (000
by default if not set)
.
2
, Press and hold the UP button for 5 seconds, the Encoder’s LED screen will show in
sequence
“IP:", "xxx", "xxx", "xxx", "xxx", which is the IP address of the Encoder.
3, Press and hold UP + DOWN buttons at the same time for 5 seconds, then release to
enter the “Configuration” mode with “CFN” displaying on the LED screen.