ASSEMBLY
Assembly of the 8” ring light kit is broken down into 5 sections:
Tripod, light and phone mount.
SECTION 1: TRIPOD
1. Take the folded tripod out of the packaging.
2. Loosen the base adjustment screw (Fig. 2).
3. Use your hands to gently pull the legs outwards from the centre shaft
(Fig. 3).
4. Adjust the legs until stable on the ground. Then tighten the base
adjustment screw.
5. Loosen the pole screws to extend to your desired height. Then tighten
once height is confirmed.
SECTION 2: RING LIGHT
1. Remove the assembled ring light from packaging.
2. Attach the ring light mount (Fig. 2) to the assembled tripod.
3. Attach the ring light to the metal mount then tighten the adjustment screw.
(Fig. 3)
4. You can tilt the ring light by loosening and then tightening the adjustment
screw once the ring light is in the desired position (Fig. 4).
INCLUDED
1
2
3
4
1
2
3
4
5
1 x 8 Inch ringlight
1 x Flexible phone mount
2 x Phone mount
1 x Clamp on mount
1 x Dual phone bracket
+
_
Brig
Warm (3200k) Lighting Mode
Brightness -
Switch On/Off
Cool (6500k) Lighting Mode
