0B
MFD ASSEMBLY INSTRUCTIONS
1B
MAIN STRUCTURE ASSEMBLY
A.
Attach Loop Upright, Base Tube, and Stabilizer using 4 – 3/8” x 8 ½” bolts, 4
– curved 3/8” washers, 4 – 3/8” flat washers and 4 - 3/8” nuts.
B.
Attach Main Upright to Base Tube using one L/H Corner Bracket and one R/H
Corner Bracket and 3 – 3/8” x 5 ½” bolts, 6 – 3/8” flat washers and 3 – 3/8”
nuts.
C.
Attach Top Beam to Loop Upright using 2 – 3/8” x 2 ¾” bolts and 2 3/8” flat
washers (no nuts).
D.
Attach the Top Beam to the Main Upright using one L/H Corner Bracket and
one R/H Corner Bracket and 3 – 3/8” x 5 ½” bolts, 6 – 3/8” flat washers and 3
– 3/8” nuts.
WEIGHT STACK ASSEMBLY
E.
Insert Guide Rods into the base of the Loop Upright. Allow Guide Rods to
lean back towards stabilizer.
Place one weight stack cushion on each Guide Rod and slide down to the
base.
Apply lubricant to the Guide Rods from the weight stack cushions to the tops
of the Guide Rods.
Making sure that the recess for the weight labels is facing towards the
machine and that the three pads are facing down slide onto the Guide Rods:
5 – 15lb. Weights, 10 – 10lb. Weights and 5 – 5lb. Weights.
Place Top Weight on the Guide Rods with the drilled hole facing the machine
and slide down to the stack.
F.
Install Upper Pulley Bracket by placing the pins into the tops of the Guide
Rods. Stand weight stack up right and fasten Upper Pulley Bracket to the
Loop Upright and Top Beam using the 2 – 3/8” x 2 ¾” bolts and 2 – 3/8” flat
washers installed in Step
C.
4