CT-MSEC ASSEMBLY INSTRUCTIONS
WEIGHT STACK AND CABLE ASSEMBLY
D1.
Insert Guide Rods into the base of the Loop Upright. Allow Guide Rods to lean back
away from the machine. Place one weight stack cushion on each Guide Rod and
slide down to the base. Apply lubricant to the Guide Rods from the weight stack
cushions to the tops of the Guide Rods.
Making sure that the recess for the weight labels is facing towards the machine and
that the three pads are facing down slide onto the Guide Rods: 10 – 10lb. weight
plates and 10 – 5lb weight plates. Place the Top Weight with Cable on the Guide
Rods with the drilled hole facing the machine and slide down to the stack.
D2.
Before proceeding with the cable installation slide the loop of the weight pin lanyard
over the end of the Upper MSEC Cable down to the top weight.
D3.
Install Guide Rod Bracket onto top of guide rods. Place the Upper MSEC Cable
over one 4 ½” pulley and slide up between the plates of the Loop Upright at the slot.
Stand the weight stack assembly upright and bolt the Guide Rod Bracket, Pulley and
Loop Upright together using 1 – 3/8” x 2” bolt, 1 - Cam Washer, 2 – 3/8” flat
washers, and 1 – 3/8” nut. Do not tighten at this time.
D4.
Place a pulley under the cable and insert between the plates of the Loop Upright.
Fasten the pulley and the triangular plate using 1 – 3/8” x 2” bolt, 2 – 3/8” flat
washers, and 1 – 3/8” nut. Use the pre-installed pin and E-clip to attach the end of
the cable to the hole in the triangular plate.
D5.
Bolt the second 5lb. weight to the selector stem using 1 - 3/8” x 4” bolt and 1 – 3/8”
nut.
NOTE:
If a heavy stack is being installed bolt the first weight plate to the
selector stem using the bolt provided with the heavy stack.
10
10
2 - Weight Stack Cushions
2 - Guide Rods
10 - 10lb. Weight Plates
10 - 5lb. Weight Plates
1 - Top Weight w/ cable
1 - 4 1/2" Pulley
1 - Guide Rod Bracket
1 - 3/8" x 2" Bolt
1 - Cam Washer
2 - 3/8" Flat Washers
1 - 3/8" Nut
1 - Upper Cable
1 - Weight Pin
w/Lanyard
1 - 4 1/2" Pulley
1 - Triangular Plate
1 - 3/8" x 2" Bolt
2 - 3/8" Flat Washers
1 - 3/8" Nut
1 - Pin and clip (in cable)
1 - 3/8" x 4" Bolt
1 - 3/8" Nut
11
D3
D5
D4
D2
D1
