- 3 -
C
ROSSOVER
I
NSTALLATION
squeeze
sides
and lift
cover
®
Passive Crossover System
20.1 XP
Figure 2
W
OOFER
I
NSTALLATION
Figure 3
Fasten the midrange through the plastic grille
tray with the screws and clips provided.
Press the metal mesh in place in the tray.
T
WEETER
I
NSTALLATION
Metal locking nut
Push the tweeter
onto the mounting cup to snap it into place.
Plastic locking nut
Drill hole
in panel
for wire to
pass through.
Figure 4
Figure 5
A N
OTE ON
P
OWER
H
ANDLING
The speakers used in Kappa Series 2-Way
Component Systems are designed to produce rea-
sonable volume levels with little amplifier power.
However, the addition of an amplifier to drive
your speakers and a subwoofer will enhance the
dynamic range of your system, and help over-
come the ambient noise in a moving vehicle.
Kappa speakers are designed to handle the power
of a dedicated amplifier driven at or below its
rated power. If an amplifier is driven far above its
rated power, the output signal will “clip,” and the
additional power present in a clipped signal can
damage any speaker. Distorted or “fuzzy” sound
from your speakers is an indication that the ampli-
fier has exceeded its rated power, and you should
reduce the volume level.
G
ENERAL
C
ARE
The loudspeaker grilles may be cleaned with a
slightly damp cloth. Do not use any cleaners or
solvents on the grilles or the speaker cones.
Kappa 40.1cs OM 7/14/98 9:57 AM Page 3
