4
Infinity Alpha 25
ES
W
ALL
-M
OUNTING
The Infinity Alpha 25
ES
speaker is designed to mount directly to a
wall. Each speaker has (4) keyholes in the rear to allow either
left- or right-side placement. Each speaker will require (2)
1-1/2," #8 wood screws fastened to a wall stud. If a wall stud is
unavailable, install an anchor appropriate for a 1-1/2," #8 screw.
Use the supplied template to accurately position the screws on the
wall and refer to the diagrams for more assistance.
NOTE:
The customer is responsible for the correct selection and
use of mounting hardware (available through hardware stores)
that will ensure the proper and safe wall-mounting of the
speakers.
Step 1.
Position the supplied wall-mount template on the wall in the
desired speaker location. Make two markings per speaker.
Step 2.
Fasten (2) 1-1/2," #8 wood screws to the wall using the markings
placed in Step 1 as your guide. Leave a 3/16" space between
the wall and screwhead. If a wall stud is not available, use an
appropriate anchor.
Step 3.
Attach speaker wire, as shown on page 5.
Step 4.
Place the speaker on the wall by aligning the upper two keyholes
on the back of the speaker to the screwheads on the wall. Once
positioned properly, the speaker should slide down slightly and
become secure.
6-5/8"
3-5/16"
14-1/2"
Nominal Inpedance: 8 ohms
Serial:
Infinity Systems, Inc.
Northridge, California
A Harman International Company
®
Alpha25es
Designed and Engineered by Infinity
Assembled in Mexico
IMPORTANT NOTE:
The set of drivers that the arrow in Figure 3
points to should be installed toward the front of the room. It does
not matter whether or not the tweeter is positioned above or
below the woofer.
This will ensure proper operation and performance should the
Monopole or Dipole position on the surround mode configuration
switch be selected.
F
IGURE
7
