Infinity IL50 L, Руководство по обслуживанию

Страница: 21 / 47

3) IL50 ADJUST BIAS PROCEDURE
(Mandatory when any output MOSFET transistors Q3,4,7,8 are replaced)
1. Locate the Linear board assembly (PCB with the output transistors)
2. Adjust R11 and R27 fully Counter Clockwise. See diagram below.
3. Apply 120 VAC power to unit, Turn power switch ON.
4. Verify LED illuminates on the front gain control dial unless you have disconnected the plug.
5. Remove shorting plug on terminal J7 on Linear board, and insert current meter, set to the low mA
range.
6. Verify initial current is less then 1 mA.
7. Adjust R11 Clockwise until current meter reads
5 mA
plus the initial current from step #6.
8. Adjust R27 Clockwise until current meter now reads
10 mA
plus the initial current from step #6.
9. Turn amplifier OFF. Disconnect AC power to unit.
10. Remove current meter; insert shorting plug back in terminal J7.
11. Replace cover (if present), wires if disconnected, and replace amplifier back into cabinet.
Location for Bias pots
21
IL50