Installation Manual
| DCIPS1B-S-00-B6 Power Supply System
38
39
+1 (208) 635-6400 | www.transtector.com
+1 (208) 635-6400 | www.transtector.com
7.2 Rectifier Replacement
NOTE
Rectifiers can be hot-swapped.
7.2.1 DCIPS1-1200 Replacement
1.
Insert a flat screwdriver into the rectangular opening next to the left handle to unlock it,
Figure 7-3 (1).
2.
Once unlocked, pull both handles down and remove the rectifier from the slot, Figure
7-3 (2).
3.
Replace rectifier. Make sure that the rectifier handle is in OPEN position (forms 35-40°
angle with rectifier body) before XPGe12.48 is fully inserted in the slot.
4.
Push both handles upwards until the left handle locks the rectifier into the correct position.
1
2
Figure 7-3 Replacing an DCIPS1B-1200 Rectifier
CAUTION
After rectifier rebooting, check that the green LED is lit.
7.3 Breaker Replacement
WARNING
Make sure the system is switched OFF.
To replace a faulty circuit breaker, follow the steps below:
1. Remove the top cover by loosening 4 screws on each side of the system and one screw
at the rear, see Figure 7-4.
Figure 7-4 Top Cover Removal
2. Pull the Faston connector from the circuit breaker, see detail in Figure 7-5 (1).
3. Press the top and bottom of the breaker, Figure 7-5 (2) to disengage it from its place and
pull it out, Figure 7-7.
