ABOUT YOUR APTO™ INFINEA® X MINI
CHARGING CUP
GETTING STARTED
Apto
™
Infinea
®
X Mini
Charging Cup
QUICK START GUIDE
PRODUCT SPECIFICATIONS
Installation
Removal
INFINEA X MINI CHARGING CUP
Mechanical
Compatibility:
Infinea X Mini with iPad mini 3
Infinea X Mini with iPad mini 2
Weight:
63 g (2.22 oz.)
Dimensions:
81.6 mm x 50.1 mm x 32.7 mm (3.21” x 1.97” x 1.29”)
Cable Length:
3’
Electrical
Connector:
USB A
Input:
5.2V 2.4A DC
Environmental
Operating Temperature:
+32°F to +95° F (0°C to +35°C)
Storage Temperature:
-4°F to +113° F (-20°C to +45°C)
The following table describes Infinea X Mini Charging Cup specifications.
Note:
When the Infinea X Mini is seated correctly, the LED will turn green to indicate the charging status. The time to charge a completely discharged Infinea X
Mini Standard Battery is approximately 3.5 hours.
INSTALLATION
(See Installation Diagram)
1.
Ensure that the environmental conditions are
within appropriate operating specifications for
the charger, as well as for the Infinea X Mini and
iOS device.
2. Clip the charging cup onto the bottom of Infinea
X Mini device and check that cup is properly
aligned and fully seated on the bottom of the IX
Mini device.
3. Plug USB connector end of Infinea X Mini
Charging Cup into approriate power supply (5.2V
2.4A, not inlcuded).
4. Confirm that the Infinea X Mini LED indicator
turns green to indicate charging is active.
REMOVAL
(See Removal Diagram)
1.
Grip the bottom of the cup with palm of hand.
2. Pull down on the rear tab with fingertips to
unlock cup from device.
3. Seperate the charging cup from the device.
