Infineon TriBoard TC3X7, Руководство пользователя

Страница: 16 / 52

User Manual 3-9 V1.2
TriBoard TC3X7 TH V1.0 and TriBoard TC3X7 V1.0 2016-08
TriBoard Manual TC3X7
Hardware: TriBoard TC3X7 TH V1.0 and TriBoard TC3X7 V1.0
TriBoard Information
3.14.5 AGBT (optional)
The TriBoard provide a 22 pin high speed samtec connector (X405) for highest speed connection via AGBT. This
connector should be assembled by your self if needed.
The AGBT interface is only available on emulation devices.
For the pinout of connector see
Figure 6-14 .
The needed Samtec connector is: ASP-137969-01 (serie ERM8, Nexus HS22).
3.14.6 ETK connector (optional)
The TriBoard provide a 10 pin samtec connector (X404) for connecting to an ETK. This connector should be
assembled by your self if needed.
For the pinout of connector see
Figure 6-12 .
The needed Samtec connector is: TFM-105-02-A.
3.14.7 EmW Power (optional)
The TriBoard provide the 4 pin power connector (X502) for the Ethernet miniWiggler (EmW). This connector
should be assembled by your self if needed.
For the pinout of connector see
Figure 6-13 .
The needed Samtec connector is the JST B4B-PH-K.
The connector provide the input voltage to the Ethernet miniWiggler and an enable/wakeup signal connected to
TLF35584 and a standby voltage of +1,25V connected to VDDSB of device. In case the EmW is used you must
remove R522. If R522 is removed then you must make sure that the EmW is always connected. Otherwise with
assembled R522 (default) you should not connect the pin 4 of connector.
The mentioned resistor is red marked in
Figure 3-6