TRAVEO II CPU BOARD
•
Ensure that jumpers J7, J6, J5, J11, J9, J41, J42 are
inserted. Ensure that Jumpers J8, J45, J10 are in
1-2 position and J46 is in 2-3 position. Ensure that the
MCU Reset Controller Jumper (J18) is inserted
CYTVII-B-H-176-SO QUICK START GUIDE
•
Insert the Traveo-II Device into IC Socket (U3), align
Pin 1 with the arrow mark near C21 and close the
socket cover
•
Connect an appropriate programming tool (IAR / GHS /
iSystem / Lauterbach), to one of the debugging
interfaces -(J21, J20, J22, J19)
Use an appropriate IDE on a PC, to load a firmware SREC file into the device flash successfully.
The LED Blink Firmware is available in the Release-Package
•
Connect the 12V Adapter to Power Jack (J1). Toggle the
switch SW1 to ON position to power up the board.
The LED1, LED2 and LED3 should light up
1
2
4
3
