User Manual
7 of 14
Rev.1.00
2020-12-03
TLD2252-2EP rear combination lamp evaluation board
User Manual
Quick start
2
Quick start
•
Connect a voltage source to VS_TAIL or VS_STOP and GND, typical 8 V to 16 V
•
Select the output current by placing jumpers at JPN_SET1 and JPN_SET2
•
Configure the diagnosis management at JPD
•
Select if PWM will be used by placing a jumper at JPPWMI (only available when suppy at VS_TAIL)
•
Select the output channels that will driven by the PWM engine by placing a jumper at JPPWMO (only
available when suppy at VS_TAIL)
•
Enable output channel 2 by placing a jumper at JPEN/DEN2 (when suppy at VS_TAIL, bypass EN1/DEN1)
•
Select load by bypassing OUT1 and OUT2 of JPOUT in order to use the on-board LED load
