User Manual
14
Revision 2.1
2018-07-09
EVAL-M1-05-65D User Manual
iMOTION
™
Modular Application Design Kit
Getting Started with EVAL-M1-05-65D
5.2
iMOTION
™
development tools and software
The iMOTION
™
Development Tool installers for MCEDesigner and MCEWizard are available for download via
Infineon iMOTION
TM
website (
http://www.infineon.com/imotion-software
). All supported tools and software
variants are listed there. Please visit this page periodically to check for tool/software updates.
Isolated on-board debugger provides the USB to UART bridge between the PC and the target iMOTION
™
device
with 1kV DC galvanic isolation between the motor drive system (hot side) and the PC/debugger (cold) side. On-
board debugger uses the SEGGER J-Link driver for UART communication with IMC101T-T038. J-Link driver will
be installed during the MCEDesigner installation. In case the driver is not installed properly, please go to
SEGGER J-Link website
to download and install the latest J-Link “Software and Documentation pack for
Windows”.
5.2.1
MCEWizard setup overview
After installing the MCEWizard, the shortcut for MCEWizard appears on the Windows desktop. Double click the
shortcut to open the MCEWizard and configure the parameters for evaluation boards or motor. Figure 6 shows
the “Welcome Page” for MCEWizard, where the MADK control board or power board can be selected through
the pull-down list. Infineon keeps releasing new MADK controller and power boards. Therefore, it could happen
that some of the newest power boards are not pre-configured in the MCEWizard tool and cannot be selected
through the pull-down menu. In that case, the user should select any other power board (as similar as possible)
and follow the MCEWizard setup steps by entering the parameter values which are specific to the chosen board.
Make sure both “I have modified the circuit board” and “Enable advanced question” checkmarks are selected.
Please refer to the Application Note of the corresponding power board for additional information.
After selecting the MADK control and the power board, start the MCEWizard system setup procedure by clicking
the “Next” button in the right bottom corner as shown in Figure 6.
Figure 6
Welcome Page of MCEWizard
iMOTION
™
MADK system enables users to easily test different combination of control and power board with
their motors. User should be familiar with the system level parameters which are related to the motor used.
There is a very limited number of parameters which are specific to the control board or power board hardware.