Infineon EVALM1099MCTOBO1, Руководство пользователя, Страница: 9 / 22

Application Note 9 <Revision 1.0>
<2017-08-21>
EVAL-M1-099M-C User Manual
iMOTION™ Modular Application Design Kit
Pin assignments
4 Pin assignments
General information about the connectors of the Eval-M1-099M evaluation board is described below.
Table 3 and Table 4 include the details of JTAG and UART connectors.
Table 3 J1- UART Connector
S. No. Pin Details
1 GND
Ground
2 RXD
Input, Receive data to IRMCK099, can be configured to GPIO pins
3 TXD
Output, Transmit data from IRMCK099, can be configured to GPIO pins
4 +3.3V
+3.3V power supply
Table 4 J2-JTAG Connector
S. No. Pin Details
1 GND
Ground
2 TMS
TMS (test mode)
3 TDO
TDO (data output)
4 TDI
TDI (data input)
5 TCK
TCK (clock)
6 RST
Not Connected
7 +3.3V
+3.3V power supply(see Specification for max current)
8 VPP
Input ,OTP Programming voltage (for IRMCK099)
Table 5 provides the pin assignments of the iMOTION™ MADK-M1 20 pins interface connector J3. This connector
is the interface to the power board.
Table 5 J3- iMOTION™ MADK-M1 20 pins interface connector for power board
Pin Name Pin Name Connectors
1 PWMUH
3.3 V compatible logic output for high side gate driver-Phase U
2 GND Ground
3 PWMUL
3.3 V compatible logic output for low side gate driver-Phase1 U
4 GND Ground
5 PWMVH
3.3 V compatible logic output for high side gate driver-Phase V
6 +3.3V
On board 3.3 V supply
7 PWMVL
3.3 V compatible logic output for low side gate driver-Phase V
8 +3.3V
On board 3.3 V supply
9 PWMWH
3.3 V compatible logic output for high side gate driver-Phase W
10
IU+ Shunt voltage phase U
11 PWMWL
3.3 V compatible logic output for low side gate driver-Phase W
12 IU-
Ground
13 GK
Gate kill signal – active low when over current is detected
14
DCBSENSE DC bus positive voltage, scaled in 0-3.3 V range by a voltage divider