Application Note
3
<Revision 1.0>
<2017-08-21>
EVAL-M1-099M-C User Manual
iMOTION™ Modular Application Design Kit
Introduction
2
Introduction
The EVAL-M1-099M evaluation board is a part of the iMOTION™ Modular Application Design Kit for drives
(iMOTION™ MADK). In order to run a motor, the mating power board is required to interface this evaluation
board.
The MADK platform is intended to use various power stages with different control boards. These boards can
easily be interfaced through the 20 pins iMOTION™ MADK-M1 or the 30 pins iMOTION™ MADK-M3 interface
connector. This board is equipped with 20 pins connector and for motor control only.
This evaluation board is designed to give comprehensible solutions of sensorless control of permanent magnet
motors over the full speed range. It consists of IRMCK099M Motor Control IC, capable of 3-phase and three
types of 2-phase modulation, JTAG and UART interface which are isolated via opto-isolation box (MCETOOLV2),
and needs a single 3.3V supply. Required Isolation Box MCETOOLV2 is not part of the EVAL-M1-099M-C kit and
needs to be ordered separately. For details of the isolation box please refer to its Application Note.
The EVAL-M1-099M evaluation board is available from Infineon and its distribution partners. The features of this
board are described in the design feature chapter of this document, whereas the remaining paragraphs provide
information to enable the customers to copy, modify and qualify the design for production according to their
own specific requirements.
Environmental conditions were considered in the design of the EVAL-M1-099M. The design was tested as
described in this document but not qualified regarding safety requirements or manufacturing and operation
over the whole operating temperature range or lifetime. The boards provided by Infineon are subject to
functional testing only.
Evaluation boards are not subject to the same procedures as regular products regarding Returned Material
Analysis (RMA), Process Change Notification (PCN) and Product Discontinuation (PD). Evaluation boards are
intended to be used under laboratory conditions by technical specialists only.
Figure 1 shows the evaluation board EVAL-M1-099M. This document explains the features and details of this
board as well as control IC which is IRMCK099.
Figure 1
Evaluation board EVAL-M1-099M