CYTVII-B-H-1M-176-CPU Evaluation Board User Guide, Document Number: 002-25907 Rev. *A
5
2.
Overview
shows the CYTVII-B-H-176-SO board. Insert a Traveo II device into the IC socket (highlighted in red) while the
evaluation board is powered OFF.
Figure 2-1. CYTVII-B-H-176-SO Board
A variant of the CPU board (CYTVII-B-H-8M-176-CPU) is also available, where the Traveo II device is soldered directly onto
the PCB. Functionally, the CYTVII-B-H-8M-176-CPU and CYTVII-B-H-176-SO boards are identical, except that the device
can be easily replaced in the latter.
For CYTVII-B-H-176-SO kit open the four screws with a screwdriver, insert the device. Make sure that the device pin number
1 mark is facing the white arrow on the PCB, which is near C21. After inserting the device close the socket cover, tighten the
screws. Make sure that the three holes on the socket cover are aligned as shown in
for the proper working of the
device.
The CPU board is meant to be used along with a Traveo II base board (CYTVII-B-E-BB). The base board brings out all
important interface connections such as CAN, LIN, SPI EEPROM, CXPI, and Flexray, and can be used in conjunction with
several CPU boards of the Traveo II family.
shows the base board.
