40
Operating the remote control
5.4
Operating the leak detector
The "START/STOP" and "ZERO" buttons on the remote
control can be used to operate the leak detector in the same
manner as on the actual leak detector.
Notice:
You must observe the operating instructions of the leak
detector in any case!
If the remote control displays a menu page of the configura-
tion, you can change to the status display of the leak detector
with "Back".
The leak detector can be in the modes „Running up“ or
„Stand-By“:
START button
Pressing the START button for the first time activates the leak
detector so that it starts measuring.
If the START button is pressed again while measuring, the
maximum leak rate display (holding function) is activated.
This displays the maximum leak rate which has occurred
since „START“.
Press „START“ again to re-initialise the holding function.
(See the Operating instructions of the leak test device used.)
Fig. 25 „Running up“ and „Stand-By“ status displays
Содержание 551-010
