INETVU® MOBILE SYSTEM QUICK START – NERA & STM
C-COM Satellite Systems Inc.
Page 5
1.3
Pre-Configuration Check List
Prior to installing IMS and configuring your system, verify that you are using the minimum
requirements listed below.
Note:
Please contact C-COM if you require more information about modem compatibility as these
may change without further notice.
Service Type
Modem Firmware
IMS 7000 S/W
IMS F/W
Interface
Nera Satlink 1000
STM Satlink 1910
9.0.1.45+
7.2.2+
7.2.2.0+
SNMP and COM
Interface
STM Satlink 2000
STM Satlink 2900
15.0.0.31+
7.5.6+
7.5.6.1+
SNMP and COM
Interface
Note:
Installed Software and Controller Firmware versions
MUST
be identical for normal operation
IP Address of Satellite Modem (if using SNMP Interface)
Satellite Name and Coordinate
Transmit and Receive Polarization (Horizontal/Vertical)
COM port users must use a standard male to female DB9 cable with the NULL Modem Adapter
attached to the controller end of the cable.
SNMP Interface Users
The SNMP community must be configured to “rw” via CLI by using the device snmp community
command
and the device manager add snmp command. This change is only required to be done once.
There are 2 methods to communicate with modem and perform the steps listed. One is HyperTerminal
and the other is via Telnet. We will illustrate the telnet method. Type the following command to make the
change.
Note: commands are to be typed without quotations.
1. Open Command Prompt after establishing a network between the PC and the Modem. Ensure
you can ping the modem from your PC
2. Type “telnet ‘modem ip’” and press Enter
3. Enter user name: “root”
4. Enter Password “nera” for Satlink 1000 and “balder1” for STM Satlink 1910/2000/2900 (default).
Check with service provider otherwise
5. The following screen will appear
