C-COM Satellite Systems Inc.
Page 9 of 29
iNetVu
®
Fly-1202 User Manual
4. System Connections
The iNetVu
®
New Generation Flyaway (Fly-1202) Antennas have been built to
operate with the iNetVu
®
7710 Central Controller and a 7720 Remote (Onboard) Drive
Module. The typical connection configuration for each service will be the same
regardless of the Satellite Modem / VSAT. However, the configuration parameters for
Satellite Modem / VSAT Communication will differ depending on service. The user may
select the connection that corresponds to his/her preferred system setup prior to
configuration. The system connections shown in this section can be used with either the
Ka or Ku systems with one variable, the Ku will have two coax connections while the Ka
in most cases will only have one.
4.1 Typical Connection with Ku Service – PC Free
Fig. 5:
iNetVu
®
7710 Controller & Ku Antenna Connection with PC Free Configuration
TX
RX
RX IN
iNetVu™
Flyaway
Platform
24 VDC Power input
(If VAC not available)
*
Ground
protection
External
grounding
connection
GPS/Glonass
Antenna
!
100 - 240VAC
RX OUT
Network
Cable
RX IN
Satellite Modem / VSAT
TX OUT
COMBINED MOTOR
& DATA CONTROL
CABLE
*Recommended for proper
grounding of iNetVu
®
systems.
RG6 Coaxial Cable
Combined Motor &
Data Control Cable
Network Cable
Power Cable
*
Ground
Connection
