15
Failure to follow this procedure may harm the belt, the workpiece or cause violent movements of
the workpiece, dangerous for the operator.
CAUTION
The motor of the grinder can be continuously loaded with the nominal power (180W) for 60 min
.
After 60 minutes, the unit should be turned off until it has cooled down to ambient temperature.
Continued operation may damage the motor and may be hazardous.
Maintaining the unit
Changing the belt
1.
Turn the unit off by pressing the red “O”
button or disconnecting the power plug from
the power outlet.
2.
Make sure that the grinding wheel is not spinning.
3.
Undo the screw securing the grinding wheel cover (#11).
4.
Uncover the grinding wheel by moving the cover (#6) to the vertical position.
5.
Take the sanding belt off the grinding wheel by pulling it perpendicular to the wheel
plane.
6.
Do not use cutting tools to cut the sanding belt. This may damage the surface of the
wheel and cause hazards!
7.
Use only a 50 x 686 mm sanding belt.
Using a different type may be hazardous!
8.
Slide the new sanding belt over the wheel, making sure that the belt is centred on the
rubber surface of the wheel.
9.
Check that the wheel moves freely.
10.
Close the grinding wheel cover to the horizontal position.
11.
Secure the cover by tightening the 2 securing bolts (#11)
