P. I. E. INEL Sp. z o. o., ul. Mostowa 1, 80-778 Gdańsk, [email protected]
www.inel.gda.pl
2.3
Electrical connections
DISCONNECT POWER SUPPLY BEFORE MAKING
ANY CONNECTIONS!
Improper roller blind installation will cause the
motor to stop unexpectedly.
3.
STARTUP
After delivery from the manufacturer the motor is factory
set. The motor will adjust to the roller blind used after
making 3 stops in the upper and lower limit position. After
that the motor will be ready for use.
The motor detects low rpm caused by overload, and locks
the direction it was moving before being stopped. In order
to unlock the direction, move in the opposite direction for at
least 1 second.
The service cable is fitted with two buttons and one switch:
(2-position, bistable) – applies voltage to the
'up' direction only.
(monostable) – allows for applying voltage to
the 'up' direction.
(monostable) – allows for applying voltage to
the 'down' direction.
Previously used service cable
The monostable "Program" button allows for
applying voltage to the 'up' direction.
The tristable switch allows for applying voltage
to the 'up' and 'down' directions.
Applying voltage to both directions at the same
time is possible after pressing both the
"Program" and "Down" switch.
5.
RETURN TO FACTORY MODE
You can return to the factory mode at any time - however, you
will need to
perform the adjustment procedure described in
section 3 again.
To enter factory mode you can use a service cable. Applying
voltage to two directions at the same time for at least 3
seconds will reset to factory mode, which will be confirmed by
a short up-down movement of the roller blind.
4. SERVICE CABLE
Before
drive
startup/programming
check
the
condition of the curtain, guides and roller blind
cassette and whether there is a sill mounted in the
window!
The roller blind cassette and guides should be free from
any contaminants and ensure unrestricted curtain
movement throughout the entire length. If the guides are
contaminated with building materials or are too tight,
they can cause damage to the drive and the roller blind,
which is not covered by the warranty.
N - neutral
PE - protective
L - phase
black
yellow-green
grey
–
not used
blue
brown
Figure 3
