Installing the Hard Disk
The system can accommodate one Serial-ATA disk. Follow
these steps to install a hard disk into the system:
Take out the hard disk tray and fix the hard disk on
1.
the tray with 4 mounting screws as illustrated in the
following picture.
Plug the Serial-ATA cable to the hard disk.
2.
Place the hard disk back to the system’s chassis and fix
3.
it with the mounting screws.
Connect the Serial-ATA power and data disk cables to
4.
the Serial-ATA power and disk connectors on the main
board respectively.
1
2
3
4
Connecting Power
Connect the IMM-L35PS to a
+9~+30V DC
power source.
The DC power-in connector comes with a 2-pin terminal
block for its Phoenix contact. This power socket can only
accept the power supply with the right pin contact so be
cautious when inserting power to the system.
dC IN
– +
Wall Mounting
The product ships with wall mounting kit. To mount your
product on the wall, follow the instructions below:
First make a hole for the anchor in the surface on the
1.
wall. Use the following diagram as a guideline for
placing the anchors.
Then press the anchor into the hole until it is flush with
2.
the surface. You may need a hammer to tap the wall
anchor.
Use a screwdriver to screw the threaded screw into the
3.
plastic anchor.
Attach the wall mounting bracket to the back of the
4.
device, securing it in place with four of the flat-head
screws provided.
Hang the device on the wall.
5.
Chapter
4
:
Hardware Setup
1
9
IM
M
-
L3
5
P
S
User Manual
