Induction Dynamics S 1.8wd, Руководство пользователя

Страница: 10 / 16

Installing the Easy-Mount Box Onto the Wall
1. The S1.8Swd is shipped pre-assembled with the faceplate attached to the easy-mount
box with bolts. In order to install the S1.8Swd onto the wall, you will first need to separate
the faceplate from the box. First, remove the grille mounting flanges, using the grille mount-
ing flange driver. Note that there may be shims under some of the grille mounting flanges.
You will need to save these shims for use when you reinstall the faceplate. Once the grille
mounting flanges and shims are removed, use a 5/16” hex key or driver to unscrew the face-
plate mounting bolts. You will later reattach the faceplate using these same bolts.
2. There are speaker wire access holes located on the back plate of the easy-mount box,
the box comes with a solid grommet pre-installed in each of the nine holes. Any solid
grommet may be replaced with a regular grommet. The grommet hole size you will need
depends on the size of the wire or screw you are putting through the hole. You will need to
feed one set of speaker wire into the S1.8Swd.
In the parts packet you will find a selection of regular grommets with holes through them
in varying sizes. Use of a snug fitting grommet is important to get a good seal around the
speaker wire or screws where they enter the box. Once you have determined the proper
grommet sizes, feed the speaker wire through its grommet. Make sure there is enough extra
speaker wire feeding into the box for easy handling of the loudspeaker faceplate.
3. If possible, find a wall stud to screw the easy-mount box into. To find a wall stud, use a
stud finder.
4. Square up the easy-mount box over the stud at listening height using a level.
5. If you can screw into a wall stud, use 2 #10 x 2” square drive round washer head screws
with metal washers (from the included parts packet). These screws should fit snugly in the
appropriate size grommet hole. Make sure that any holes not used for mounting or running
speaker wire have solid grommets in them. These solid grommets not only seal the box, but
also act as a rubber cushion between the box and the wall.
6. If you cannot screw into a wall stud, use 4 dry wall anchor bolts that spread out behind
the drywall. Select grommets that fit snugly around the bolts you have chosen. Be sure to
put a metal washer between the head of the bolt and the grommet.
8
Audio Perfection Realized
™