Induction Dynamics C2.w, Руководство пользователя

Страница: 9 / 14

8
Audio Perfection Realized
™
6. If you cannot screw into a wall stud, use 4 dry wall anchor bolts that spread out behind
the drywall. Select grommets that fit snugly around the bolts you have chosen. Be sure to
put a metal washer between the head of the bolt and the grommet.
Installing the Faceplate
1. Attach the speaker wire to the terminal block on the back of the faceplate, observing
the proper polarity (red to red and black to black). To make connections, solder or crimp
with high pressure the insulated fork terminals provided in your parts packet. Soldering is
best.
2. Position the speaker faceplate over the easy-mount box. Be careful to route the speaker
wire so it is not between the bottom of the box and a cage, or between the top ot the box
and the faceplate. If necessary, the wire may run alongside a cage. Screw in the faceplate
mounting bolts, gently tightening each one a little at a time, until the faceplate is moder-
ately snug. DO NOT TIGHTEN THE BOLTS ANY FURTHER. The rubber gasket provides
the seal.
3. Replace any shims (mentioned earlier) in their proper location. Use the grille mounting
flange driver to screw in the grille mounting flanges. The grille mounting flanges should
be used even if the grilles are not, as this gives the loudspeakers a finished appearance.
4. Attach the cloth grille by carefully pressing into the grille mounting flanges.
Connecting to an Amplifier
1. Be sure the amplifier is turned off to avoid damage to the speakers.
2. Connect the speaker wires to the speaker outputs on your amplifier. Observe proper
polartity (red to red and black to black).