Indramat TDA 1, Руководство по планированию проекта

Страница: 22 / 50

22 • DOK-DIAX01-TDA********-PRJ1-EN-E1,44 • 07.97
2.4. Electrical data
Connection diagram
(schematic)
2. Control cabinet design
The connection diagram shown in Fig. 13 is of a schematic nature. It
serves as a check list for all electrical connections required to operate a
main spindle drive.
The electrical connections of INDRAMAT main spindle drives have been
standardised in order to restrict the variety of cable types.
All INDRAMAT main spindle drives are equipped with three categories
of electrical connections:
– feedback and NC connections
– power connections
– connections specific to the controller
Irrespective of the type of main spindle unit, the feedback, NC and power
connections are all configured with the same plug-in connector or
terminal assignments. The connection diagrams are therefore contained
in the documentation "Electrical connections of main spindle drives;
Project planning" (No. 209-0042-4111). This documentation is indispen-
sable when preparing the machine circuit diagram!
In addition to the connections mentioned above, certain specific connec-
tions are required to integrate the controller TDA 1 into the drive package
(see Fig. 16 and 17). These connections are shown in the schematic
connection diagram (Fig. 13).
Programming module AS
Connection diagrams for
feedback, NC and power
connections
Connections specific
to the controller