Indigo NAUTILUS XP, Руководство пользователя

Страница: 7 / 14

Replacing the Battery Cont.
•
Disconnect the connector and carefully pull the battery module from the tube.
• Repeat on the second tube.
• Plug in the batteries to the charger provided. The charger can charge both
batteries at the same time.
• While charging, the indicator light on the charger will remain constant red.
Once charged, it will change to green. Waiting an additional 30-minutes after
green on the initial charge will balance the cells.
To replace the batteries, repeat in reverse the removal steps. Hold the wires and plug in the
tube to the inside while sliding the battery in. This will avoid pushing the wires into the
tube or damaging them The module nests into the center of the rear cap. If the module
doesn't drop completely into the tube, pull it out ½ inch and reposition until the modules are
centered. DO NOT USE FORCE. The module should sit easily into the tube and front cap.
Inspect the O-rings on each cap for signs of wear. Replace every ten removals regardless of
apparent condition. To replace:
• Using an O-ring removal tool hook the inner O-ring and slide it over the outer
O-ring and off of the cap. Remove the outer O-ring next. This sequence
prevents the inner O-ring from falling into the vacant outer O-ring groove.
• Ensure that there are no foreign objects in the O-ring grooves.
Carefully clean with a cotton swab
• Apply Molykoto 111 Grease to the new O-rings and carefully stretch them into
their respective grooves beginning with the first or out groove. Next stretch the
inner O-ring over the outer O-ring and into it’s groove.
• Ensure that the O-rings are seated completely in the groove.
• You may now install the end cap.
6