Indian Motorcycle SCOUT BOBBER 2021, Руководство пользователя

Страница: 71 / 162

6. Reinstall the drain plugs.
TORQUE
15 ft-lbs (20 N
·
m)
7. Place a drain pan or shop towels under the oil filter. Using an oil
filter wrench, turn the filter counter-clockwise to remove it. If
necessary, remove the horn bracket to improve access.
8. Using a clean dry cloth, clean the filter sealing surface on the
engine.
9. Lubricate the o-ring on the new filter with a film of fresh engine
oil. Check to make sure the o-ring is in good condition.
10. Install the new filter and rotate it clockwise by hand until the
filter gasket contacts the sealing surface, then turn it an
additional 3/4 to one full turn.
11. Reinstall the horn bracket if it was removed.
12. Remove the dipstick. Using a funnel, add 3-4 qt (2.8-3.8 L) of
the recommended oil. Reinstall the dipstick securely.
13. With the motorcycle in an upright, centered position, start the
engine and allow it to idle for 30 seconds. Stop the engine.
14. Add the recommended oil as needed to bring the level to the
FULL mark on the dipstick. Verify the level on the dipstick.
NOTICE
The approximate volume between the ADD and FULL marks on
the dipstick is 16 fl oz (.45 L).
15. Reinstall the dipstick securely
NOTICE
Do not overfill. Overfilling can result in loss of engine
performance and an oil-saturated air filter. Use a suction device
to remove excess oil if overfilled.
16. Dispose of used filter and oil properly.
NOTICE
After an oil change, the low oil pressure indicator may illuminate
when the engine is started. If this occurs, do not increase RPM
above idle speed until the indicator turns off. Operating above
idle speed could result in damage to the engine.
CCOOOOLLIINNGG SSYYSSTTEEM M
The engine coolant level is controlled by the recovery system.
Recovery system components are the recovery bottle, the radiator
filler neck, the radiator pressure cap and the connecting hose.
As coolant operating temperature increases, the expanding
(heated) excess coolant is forced out of the engine, past the
pressure cap, and into the recovery bottle. As engine coolant
temperature decreases the contracting (cooled) coolant is drawn
back up from the bottle, past the pressure cap, and into the
radiator.
Some coolant level drop on new vehicles is normal as the system is
purging itself of trapped air. Check the coolant level and maintain
as recommended by adding coolant to the recovery bottle.
69
MAINTENANCE