Indian Motorcycle Indian Challenger 2020, Руководство пользователя

Страница: 141 / 178

• If it is necessary to provide power to an item that does not use
one of the previously mentioned power jacks, connect to the
load side of the main circuit breaker and connect the ground
wire to the engine ground at the front side of the crankcase
(near the circuit breaker). The circuit breaker is located under
the cover behind the oil cooler.
• DO NOT splice or cut any wires.
• DO NOT tap in to any power or ground on the motorcycle unless
specifically directed to do so by the INDIAN MOTORCYCLE
instructions that come with the kit.
• DO NOT back-probe electrical connectors on the vehicle unless
directed to do so by the INDIAN MOTORCYCLE Service Manual .
• DO NOT power any accessories from the diagnostic connector
(under left side cover).
UUNNLLOOCCKKIINNGG TTHHEE SSEECCUURRIITTYY SSYYSSTTEEM M
Your dealer will provide the master personal identification number
(PIN) for the security system. Your dealer may also change the
master PIN to a new rider PIN on your behalf.
Record both PINs on page 7.
Change the dealer-provided PIN to a PIN of your own choosing as
soon as possible after receiving delivery of your new motorcycle.
See page 139.
If a key fob is not available, your rider PIN can be entered using
the Ride Command display to unlock the security system.
CCHHAANNGGIINNGG YYOOUURR SSEECCUURRIITTYY SSYYSSTTEEM M PPIINN
To change your PIN, you must have either the key fob or your
existing valid PIN available to gain access to the security system. If
the key fob is not detected or is not available and you cannot
remember your PIN, please see your INDIAN MOTORCYCLE
dealer.
Please read the entire procedure before beginning.
1. Turn the power switch on. Do NOT start the engine. The
security light and/or power switch will turn on briefly until the
key fob is detected or until the valid, current PIN is entered.
2. Push or hold the turn signal CANCEL switch for 10 seconds
until the security light and/or power switch turn on.
NOTE
On models with Infotainment Display, a pop-up window will
appear during this procedure stating that the key fob is out of
range.
3. Enter either the master PIN (see page 7) or your current 4-digit
rider PIN within 20 seconds. If the PIN is successfully entered,
the security light and/or power switch will remain on and the
horn will sound briefly.
TIP
If the valid PIN is not entered within 20 seconds, the security light
and/or power switch will flash for 10 seconds, then the system
will shut down. Return to step 1 to try again.
139
MAINTENANCE