P/N 9925955 Rev 02 04/15 Page 8 of 9
38. Now locate the mating plugs.
a. In the front of the vehicle, between the frame
and left fork and between the upper and lower
triple clamps you’ll find an unused gray eight
pin JST connector (U) shown in figure (this is
the part of Audio Harness Kit P/N 2880302).
Connect with audio wire harness.
b. In the underseat area, connect the saddlebag
audio wire harness (V) and plug the black and
blue power/ground connector into the mating
black/blue connector on the trunk wire
harness bundle (W) shown in figure.
U
V
W
39. After making connections at both ends, starting at the rear of the vehicle, put the wire in final position,
and tighten the nearest zip ties. Follow the wire towards the front of the vehicle, making adjustments to
final routing and tightening zip ties as you come to them. Any slack should be captured in the fairing of
the bike.
40. Installation of console is reverse of removal.
a. Fuel Tank Screws
12 ft. lbs. (16.3 Nm).
b. Seat Screws:
18 ft. lbs. (24.4 Nm).
c. 4 mm Socket head screws for tank:
84 in-lbs. (9.5 Nm).
41. Route zip tie (X) as shown after reinstalling the
wire tray cover. Trim excess length.
X
