Description
Brake kit (swing damper only)
Brake function
The brake kit is designed to brake the swinging movement in the actual direction. To ensure
correct functioning, clean grease and oil from the brake disc.
Warning
Image 6
1.
Locking ring
Locking rings are a safety detail which stop parts being thrown out from the sprung brake
unit if a screw is damaged. It is important that the locking ring is correctly in place during
adjustment/tightening. Only when the brake unit springs are not pressurised (loosely
adjusted) may the locking rings be removed, for example when changing the brake blocks.
Adjustment
Image 7
1.
Locking nut
2.
Screw joint
3.
Flange nut
4.
Screw
For safety reasons, keep the locking rings in position. Loosen the locking nut before
tightening. Hold the flange nut and tighten the screw. The maximum tightening torque
for the screw joint is 30 Nm. Wear increases if tightening torque too high. After adjusting,
the screw joint is locked by the locking nut.
1102 029
2017-08-21 13:36
© Indexator AB
13
