Service Manual
Manual LFT 228-320 - 321
Edition
2007.10.15
Language
English
12
Sparkleing Rinse Agent check via LED
The administering of Sparkling-rinse agents on Model EOS is done through a “Magnetic Read”sensor, mounted right inside the
dispenser. It detects the presence or absence of the Sparkle-agent by means of a floating-ball. The User-Interface will read the
message and will transmit it directly to the Main-board; which in turn will decide whether or not it should switch the Led on or off
at the same time, informing the User-Interface of its decision.
Setting Hard-Water:
Whereas in the previous model, the “regenerating” process was done at the end of each washing-cycle (except in the soak-
cycle), on model EOS, the regenerating-process depends on the “settings/conditions” of the dishwasher.
Thus when first setting up the dishwasher or whenever the Main-board's being replaced, it's important to set the water-hardness
in order to prevent the resines used in the sweetening of the water from being used up and which would lead to bad functioning of
the dishwasher.
Dishwashers coming out from plants are on default and set on “3” and “30” for the French, and the “regenerating” cycle is done
every 65 litres that have been filled up.
When using multi-functional tablets:
The water-hardness should always be indicated, as should be done whenever another type of detergent is being used;
when multifunctional tablets are being used, the salt-container should always be filled up.
It is recommended not to add salt from 0°f to 10°f.
HOW TO SET WATER-HARDNESS ON THE MACHINE
First check to see that the dishwahser is not on and that the door is open.
1.
Switch on the dishwasher on “Power On”.
2.
Soon after, press button “P” and keep pressed for about 6 seconds. A number relating to the level that as been set will
come on display.
3.
By pressing button “P”, the water-hardness may be modified: 1-2-3-4-5; and by keeping it pressed it will go back
repeating 1-2-3-4-5-12-3-...etc.
4.
Once the selection has been made, a further 10 seconds must be waited till the machine takes up the reading
automatically.
NB: The “regenerating” cycle of the resines is not done as frequently as on previous models but as according to the
hardness of the water and quantities of water that have gone to fill up the dishwasher, and ONLY where it had been
envisaged on certain programmes, therefore not on the “soak cycle”. Should the quantity of water filled up into the
dishwasher exceed the quantity established by Editor (consult enclosed Table), once having reached the prescribed-
level at the end of the cycle, the dishwasher will automatically proceed with the “regenerating” of resines.
